Adjusting The Drive Control Cable - Wacker Neuson RD 12A Repair Manual

Drive System

5.2 Adjusting the Drive Control Cable

If the roller tends to drift in either direction when the forward/reverse control is in
Background
NEUTRAL, the drive control cable (a) must be adjusted.
Machine on a hard, level surface
Prerequisites
Engine running
Forward/reverse control in the NEUTRAL position
Follow the procedure below to adjust the drive control cable.
Procedure
1. Loosen the lock nut (b).
2. Move the turnbuckle (c) as needed until machine movement stops.
If adjusting the turnbuckle does not achieve the desired results, a gross adjustment
can be made at the nut (d) and then fine-tuned as described above.
The drive control cable has now been adjusted.
wc_tx000667gb.fm
b
c
a
50
RD 12/RD 12A
d
wc_gr004121