Electrical Connection - Zanussi ZHQ 631 Instruction Booklet

Electrical connection

Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load;
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used for
the electrical connection can be easily reached with
the appliance built in the forniture unit.
This appliance is supplied without connection cable. A
suitable one must be fitted, in compliance with the electric
supply rate. Only the following cable types must be used:
H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F. A suitable plug, able to carry the load
specified on the rating plate, must be fitted to the cable.
The plug has to be fitted in a proper socket.
If connecting the appliance directly to the electric system,
a double pole switch must be installed between the
appliance and the electricity supply, with a minimum gap
of 3 mm. between the switch contacts and of a type
suitable for the required load in compliance with the
current rules. The earth wire must not be interrupted by
the double switch pole.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature 50 °C higher
than the room temperature.
After the connection is carried out, test the heating
elements for about 3 minutes.
Connection to terminal block
This appliance is provided with a 6 poles terminal block
(Fig. 17) set to operate with a 400 V three-phase electrical
supply with neutral wire.
To adapt the the terminal block to a different electrical
supply, carry out the connection as shown in Fig. 18.
The earth wire must be connected to terminal marked
. Once the connection is carried out, fit the cable into
the the cable clamp.
Electrical connection with the
hob
This oven can be connected to hobs indicated in the
"Technical Assistance" section. The socket for connecting
the hob is located at the top of the oven cabinet. The
hobs come complete with connecting leads for the hot
plates/heat areas and ground cable; these leads feature
plug-in connectors. Connection of the hob to the oven is
carried out by plugging-in these connectors to the cor-
responding oven socket.
The plug-to-socket connection design is such as to
prevent possible wrong plugging-ins.
The manufacturer
responsability should all the safety
measures not be carried out.
14
disclaims any
Fig. 17
FO 0330
1 2 3 4 5
230V 3~
L1
1 2 3 4 5
230V 1~
L1
1 2 3 4 5
400V 2N~
L1 L2
1 2 3 4 5
400V 3N~
L1 L2 L3 N
Fig. 18 FO 0584
L2 L3 PE
N PE
N PE
PE