Table of Contents
Advertisement
696
7-2. Steps to take in an emergency
Connect the jumper cables according to the following procedure:
3
Connect a positive jumper cable clamp to the exclusive jump
1
starting terminal on your vehicle.
Connect the clamp on the other end of the positive cable to the
2
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
3
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
4
solid, stationary, unpainted metallic point away from the exclusive
jump starting terminal and any moving parts, as shown in the
illustration.
Start the engine of the second vehicle. Increase the engine speed
4
slightly and maintain at that level for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
Open and close any of the doors of your vehicle with the power
5
switch off.
Maintain the engine speed of the second vehicle and start the
6
hybrid system of your vehicle by turning the power switch to ON
mode.
Make sure the "READY" indicator comes on. If the indicator does
7
not come on, contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
UK_AURIS/AURIS_HV_EE (OM12F76E)
Advertisement
Table of Contents
