Toyota Auris 2013 Owner's Manual page 676

676
7-2. Steps to take in an emergency
CAUTION
 When fixing the flat tire
After inflation of the tire has completed, the sealant may splatter when the

hose is disconnected or some air is let out of the tire.
 Follow the operation procedure to repair the tire. If the procedures not fol-
lowed, the sealant may spray out.
 Keep back from the tire while it is being repaired, as there is a chance of it
bursting while the repair operation is being performed. If you notice any
cracks or deformation of the tire, turn off the compressor switch and stop
the repair operation immediately.
 The repair kit may overheat if operated for a long period of time. Do not
operate the repair kit continuously for more than 40 minutes.
 Parts of the repair kit become hot during operation. Be careful when han-
dling the repair kit during and after operation. Do not touch the metal part
around the connecting area between the bottle and compressor. It will be
extremely hot.
 Do not attach the vehicle speed warning sticker to an area other than the
one indicated. If the sticker is attached to an area where an SRS airbag is
located, such as the pad of the steering wheel, it may prevent the SRS air-
bag from operating properly.
 Driving to spread the liquid sealant evenly
Observe the following precautions to reduce the risk of accidents.
Failing to do so may result in a loss of vehicle control and cause death or
serious injury.
 Drive the vehicle carefully at a low speed. Be especially careful when turn-
ing and cornering.
If the vehicle does not drive straight or you feel a pull through the steering

wheel, stop the vehicle and check the following.
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If the tire inflation pressure is 130 kPa (1.3
2
kgf/cm
UK_AURIS/AURIS_HV_EE (OM12F76E)
or bar, 19 psi) or less, the tire may be severely damaged.