Table of Contents
Advertisement
1ND-TV engine
Connect a positive jumper cable clamp to the positive (+) battery
1
terminal on your vehicle.
Connect the clamp on the other end of the positive cable to the
2
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
3
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
4
solid, stationary, unpainted metallic point away from the battery
and any moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed
4
slightly and maintain at that level for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
Open and close any of the doors of your vehicle with the engine
5
switch off.
Vehicles without a smart entry & start system:
6
Maintain the engine speed of the second vehicle and turn the
engine switch to the "ON" position, then start the vehicle's engine.
Vehicles with a smart entry & start system:
Maintain the engine speed of the second vehicle and turn the
engine switch to IGNITION ON mode, then start the vehicle's
engine.
UK_AURIS/AURIS_HV_EE (OM12F76E)
7-2. Steps to take in an emergency
691
7
Advertisement
Table of Contents
