Chapter 3: Operation; Power - Elo Touch Solutions ESY13P1 User Manual

Chapter 3: Operation

Power

To turn the PayPoint Register on and off, press the register power button once. Pressing power
button when the register is on will bring up the Shut Down option screen (refer to Figure X).
Insert Shut Down option screen
In the event that the register freezes and does not respond, press and hold the power button
until the register turns off. If the register does not turn off via the power button, the register will
need to be powered down by unplugging the power cord from the wall.
The PayPoint register Power button is equipped with an LED that indicates the power status of
the register, as follows:
The system consumes low power when in SLEEP and OFF modes. For detailed power
consumption specifications, refer to technical specifications available on the Elo website
www.elotouch.com.
To bring register out of sleep/standby mode, press the power button once.
If long periods of non-use are planned, turn off the PayPoint Register to save power.
The maximum voltage, frequency and current for the register, are provided in the power ratings
table below:
PayPoint Register
Register Power Status
OFF (disconnected from wall)
OFF (connected to wall)
SLEEP
ON
Operating Voltage
Range
100 - 240Vac
LED Status
Red
Blinking white light
Solid white light
Operating
Frequency Range
50/60 Hz
Off
Operating Current
Range
User Manual: Elo
SW602189 Rev A, Page 11 of 24
®
Paypoint