a professional installer for advice. The power and signal quality indicators refer
to the first transponder of the chosen satellite list.
Changing the DiSEqC 1.0 / 1.1 parameters, DiSEqC 1.2 / DiSEqC 1.3 , you will get
three different configuration modes.
8.1 Simple installation
For the single inverter antenna (LNB)/satellite with direct connection between
the TV and antenna, they DiSEqC commands or other special communication
protocols are not used.
8.1.1 Antenna and satellite configuration
From the Antenna setup menu make the following choices:
Satellite : Satellite choice of interest. Highlight the Satellite confirm by
1.
pressing OK and press ►.
LNB type : Type of converter (Low Noise Block converter - LNB) associated
1.
to the chosen satellite. For common satellite systems used in Italy, The
Universal (9750/10600) is used.
2.
LNB power : LNB power supply for switching between horizontal and
vertical polarization. Generally it must be maintained active (13 / 18V). Its
inactivation is rather useful when you realize IF-IF distribution plants (for
Expert users).
22KHz : 22KHz signal switching between high and low band
3.
Tone burst : none
2.
DiSEqC 1.0 : none
3.
DiSEqC 1.1 : none
4.
5.
Motore: none
8.1.2 Channel search for satellite
After setting the configuration, to search channels on the chosen satellite press
the BLUE button Scan and define the following parameters in the Channel
Search dialogue window:
Scan type : scanning mode following the transponder database (default
1.
option) or blind-scan frequency steps (Blind-Accurate option) or via
network (network option) that scans the active transponders.
Channel type : choose free to air channels to only search for Free
2.
channels (recommended), Scramble only for encrypted channels or
Free+Scramble to scan both types.
15