Standard And Advanced Modes; Storing Measurements Into Memory; Displaying Stored Measurements; Installing Dataview - AEMC 6417 Quick Start User Manual

Standard and Advanced Modes

The Ground Resistance Tester has two modes:
• Standard Mode: Makes the standard loop resistance/impedance and current
clamp measurements.
• Advanced Mode: Used to refine and complete the measurements:
- Impedance referred to the selected frequency.
- Contact voltage.
- Resistive and inductive fractions of the loop impedance.
The choice of the Standard or Advanced mode and the alarm thresholds are
configured in SET-UP.

Storing Measurements into Memory

The values displayed during the measurements can be stored in memory and read
later. Storage of the data is available in both the Ω+A and A measurement modes,
provided that memory locations are free. Data is stored as soon as the MEM button is
pressed. A long audible signal confirms the storage.

Displaying Stored Measurements

• Set the function switch to the MR position.
• The type of data that is displayed is dependent on whether Standard or Advanced
mode was selected during SET-UP.

Installing DataView

DO NOT CONNECT THE INSTRUMENT TO THE PC BEFORE INSTALLING THE SOFT-
WARE AND DRIVERS.
Insert the USB stick into an available USB port (wait for the driver to be installed).
1.
If Autorun is enabled, an AutoPlay window appears. If Autorun is disabled, open
Windows Explorer, then locate and open the USB stick drive labeled DataView.
2. In the AutoPlay window, select Open folder to view files.
3. Double-click on Setup.exe to launch the Dataview
NOTE: For more information on using the DataView
6417 user manual supplied on the USB stick.
NOTE: You can retrieve and analyze measurement results with the DataView
ware or with an Android app through the Bluetooth communication port.
®
setup program.
®
software, refer to the Model
®
soft-
®