Getting Started; Turning The Instrument On; Turning Bluetooth On; Inserting The Batteries - AEMC 6417 Quick Start User Manual

Getting Started

Inserting the Batteries

WARNING: Do not clamp onto a conductor during a measurement.

Turning the Instrument ON

With the clamp closed and not clamped around any conductor, set the rotary switch to
a position other than OFF. All icons on the display light for approximately two seconds,
before possible entry of the date and time.

Turning Bluetooth ON

• Turn the rotary switch to the MR or Setup position., then press and release the
HOLD /
When Bluetooth (BT) is ON you will see the Bluetooth icon ( ) at the bottom of the
display.
To turn Bluetooth OFF, repeat the steps above. Once Bluetooth is ON you can rotate
the rotary switch to any position (except OFF) and Bluetooth will remain ON.
NOTE: When setting up the Bluetooth connection between the instrument and your
PC, you may be prompted to enter a pass code on the PC. If so, enter 1234 for the
pass code.

Setting the Date and Time

Setting the clock, which allows time-stamping of the measurements, is done only the
first time the device is used or after the device has been without battery power for
more than 2 minutes.
Set the function switch to Ω+A. All icons on the display light for approximately two
seconds. Enter the date and time of the device using the ▲, ▼, and ► buttons.
The date and time can also be configured before a measurement in SET-UP.
+ +
+ +
button.
• Disconnect the instrument from any
connections and turn the rotary switch to
the OFF position.
• Use a Phillips head screwdriver to
unscrew the 2 attachment screws and
remove the battery compartment cover.
• Remove the old batteries and replace
them with 4 new batteries (LR6, AA,
1.5V), observing the polarities.
• Close the battery compartment cover and
screw the two screws back in.
• Check the proper operation of the device.