Software Installation And Setup - Monoprice MP Mibi Delta User Manual

5. The SSID of your Wi-Fi® network should be displayed on the screen of your device. If
a different SSID is displayed, open your device's Wi-Fi settings and select the
appropriate Wi-Fi network.
6. Enter your WiFi network password.
7. With the printer idle, press and hold the Quick Access LED Button (5) for 4 seconds
to initialize the built-in Wi-Fi Smart Config function. Continue holding the button
until Smart config started is displayed on the screen of your mobile device.
8. Press the Connect to WiFi button on your mobile device. The connection will be
completed within 10 ~ 60 seconds and the message MP 3D Printer is now
connected to Wi-Fi will be displayed on your device's screen and the IP address will
be displayed at the top of the printer's LCD screen.
Note that you may have difficulty connecting to the Wi-Fi network if you have a 2.4GHz
and 5GHz network with the same SSID. Try changing the SSID of the 5GHz network if this
occurs. For best results, move the printer to a location closer to the Wi-Fi router or access
point.

SOFTWARE INSTALLATION AND SETUP

As you've seen, you can print a model directly from a gcode file on a microSD™ card and
this is the preferred method, as it does not require a continuous connection to your
computer. You can download gcode files to the microSD card and print them without
having to build any model files.
However, you can create your own gcode files using an open source program, such as Cura
or Repetier-Host, which are pre-installed on the microSD card that comes with the printer.
These programs use M200 models (typically .STL or .OBJ files) and, using machine specific
information, generate a gcode file with detailed instructions for the printer to create the
selected model. We recommend you start with Cura, since it includes a Slicing Engine.
11