Completed Print Removal; Wi-Fi Setup - Monoprice MP Mibi Delta User Manual

17. Use the top and bottom buttons to highlight the auto00.g file (formerly cat.gcode),
then press the center button to start printing the model.
Congratulations, your 3D printer is setup and you are printing your first model!

COMPLETED PRINT REMOVAL

Perform the following steps to remove a completed print.
1. Wait until the heated bed has cooled to room temperature.
2. Using the included Plastic Scraper, try to wedge it under the print.
3. Continue pushing until the print begins to lift off the bed, try to push the scraper
further under the print.
4. If you encounter difficulty pushing the scraper under the print, try approaching it
from another side or try working the scraper around the perimeter of the print.
Continue pushing until you can slide the scraper all the way under the print, then lift
the printed model off the bed surface.

WI-FI SETUP

You can connect the printer wirelessly to a 2.4Ghz Wi-Fi® network to print models from
your Android™ or iOS® phone or tablet. Perform the following steps to setup the Wi-Fi
connection for your device.
1. Download and install the free MP 3D Printer WiFi Connect app from the Google
Play™ store or from iTunes®, depending on which type of mobile device you have.
2. Disconnect the USB cable from the printer. You cannot use USB and Wi-Fi
connections at the same time.
3. Power on the printer.
4. Start the MP 3D Printer WiFi Connect app on your mobile device.
10