Chapter 5: Parts Replacement Guide; Tension Control Replacement - Matrix S-Drive Service Manual

5.1 TenSion conTrol rePlacemenT

1) Remove the 2 screws holding frame cover (Figure A).
2) Take off the tension control wire (Figure B).
3) Remove the tension control wire from frame (Figure C).
4) Tie the wire on damaged tension control wire. When you pull out tension control wire, the wire will be inside console mast, so it is easier to
replace new tension control wire (Figure D).
5) Remove the 6 screws holding arm rest set (Figure E & F).
8

cHaPTer 5: ParTS rePlacemenT GUiDe

fiGUre a
fiGUre c
fiGUre e
fiGUre b
fiGUre D
fiGUre f