cHAPter 8: PArt rePlAceMent gUide
8.1 front disk reMoVAl
figUre A
figUre b
figUre d
1) Remove the link arm and pedal arm plastic caps (Figures A and B).
2) Detach the dual-action handlebar at the pedal arm (Figure C).
3) Detach the link arm from the crank bearing assembly (Figure D).
4) Rest the link arm padded surface on the front stabilizer (Figure E).
5) Press the center cap and turn it counter clockwise to remove (Figure F).
Remove the 24mm locking nut and washer by turning them counter
6)
clockwise (Figure G).
7) Thread the Matrix disk removal tool into the center hub (Figure H).
8) Turn the center bolt of the removal tool clockwise until the main
disk can be removed (Figures I and J). Repeat if necessary for the
opposite side disk.
9) When reinstalling the 24mm nut, it should be tightened to 196 N-m
Torque.
figUre c
figUre e
27