Installation Instructions; Verifying The Package Contents; Installing The Chassis; Connecting The Cooktop Wiring - Dacor Discovery DYTT365N Installation Instructions Manual

Verify the Package Contents
Verify that all these items have been included:
• DYTT Induction Glass Cooktop
• Foam tape
• Hold-down brackets (2)
• Glass scraper (PN 82499)
• Dacor Cooktop Cleaning Creme (PN A300)
• Product literature
If any item is damaged/missing, contact your dealer imme-
diately. Do not install a damaged/incomplete appliance.
Before starting the installation, make sure you have all the
equipment you need for proper installation.

Installing the Chassis

If the electrical service provided does not meet the speci-
fications on Pg. 3, discontinue the installation. Call a
licensed electrician to install the required wiring.
IMPORTANT
• Before installing the cooktop, verify that all minimum
clearances are met as specified on Pg. 4.
• Do not use a hardening compound, glue, or caulk to
seal the cooktop in place. The cooktop must be readily
removable for service. Removal of sealant to service
the unit will be charged to the customer.
1. Peel the protective backing from the foam tape provided,
and attach the tape to the bottom of the cooktop mount-
ing surface (as near the edge of the glass as possible).
2. Keeping the cooktop centered, lower it into the cutout.
3. With the two hold-down brackets provided, secure the
cooktop to the countertop.
8

Installation Instructions

WARNING
4. Slide the brackets into the slots on the left and right
sides of the chassis, then tighten the screws to the
underside of the countertop. (Do not overtighten the
screws.)

Connecting the Cooktop Wiring

• To prevent electric shock or fire hazard, turn off power
at the circuit-breaker panel or fuse box before connect-
ing the cooktop wiring.
• Failure to connect the cooktop wiring as specified may
result in an electric-shock hazard, a fire hazard, and
damage to the appliance.
• Connect the cooktop's ground (green) wire to a ground-
ed, metallic, permanent wiring system or grounding
conductor. Do NOT ground the appliance to a neutral
(white) house-supply wire. You must use a separate
ground wire.
• This appliance must be properly grounded according to
these instructions whenever power is applied.
• If aluminum house-supply wiring is used, splice the
appliance copper wires to the aluminum house wiring
using special connectors designed and agency-certified
for joining copper and aluminum. Follow the connec-
tor manufacturer's recommended procedure carefully.
Improper connection may create a fire hazard.
IMPORTANT
Provide slack in the conduit so the cooktop can be
removed for service.
1. At the circuit breaker or fuse box, turn off power to the
circuit to which the cooktop will be connected.
2. Feed the appliance conduit into the junction box, and
attach it using a UL-certified strain relief.
3. According to local codes, use one of the two methods
shown on the next page to connect the appliance to the
junction box.
WARNING