GE MDS Master Station Technical Manual page 37

If you wish to...
Create a one-time password
View all network interface
status and statistics
Create a bridge
Add the ETH1 interface to a
bridge
Remove the ETH1 interface
from a bridge
View SDMS Settings
Monitor SDMS Status (RSSI,
SNR, etc)
Configure SDMS
Frequencies
Configure SDMS Modem
Configure the SDMS Radio
Mode
Configure SDMS Radio
Power
Key/Dkey the SDMS Radio
Send a Remote Maintenance
Request to Remotes
View the routing table
View the event log
Set the admin user's
password
Set the device name
Set the baud rate on COM1
Download a firmware
package from TFTP server at
192.168.1.10
Monitor firmware download
status
Export configuration file to a
TFTP server at 192.168.1.10
Reboot device to firmware
inactive image
MDS 05-6399A01, Rev. E
Table 5-1. CLI Quick Reference Table
> request system recovery one-time-password create function <user
function>
> show interfaces-state interface
% set interfaces interface bridge type bridge
% set interfaces interface bridge bridge-settings members port eth-0/0/0
% delete interfaces interface bridge bridge-settings members port
eth-0/0/0
> show configuration interfaces interface sdms sd-config
> show interfaces-state interface sdms sd-status | repeat 5
% set interfaces interface sdms sd-config radio-config basic-config
receive-frequency <value>
and/or
% set interfaces interface sdms sd-config radio-config basic-config
transmit-frequency <value>
% set interfaces interface sdms sd-config radio-config basic-config
modem-type <modem>
% set interfaces interface sdms sd-config radio-config basic-config
radio-mode <radio mode>
% set interfaces interface sdms sd-config radio-config basic-config
rf-output-power <value>
> request interfaces interface sdms sd-config maintenance rf-key-test
key radio true/false
> request interfaces interface sdms sd-config maintenance
remote-management-command <command name> <value>
> show routing
> show table logging event-log
> request system authentication change-password user admin
password admin1234
% set system name "Mydevice"
% set services serial ports COM1 baud-rate b19200
> request system firmware reprogram-inactive-image filename
sdms-bkrc-1_0_0.mpk manual-file-server { tftp { address 192.168.1.10 } }
> show system firmware reprogramming-status
> request system configuration-files export filename myConfig.xml
manual-file-server {tftp {address 192.168.1.10} }
> request system power restart inactive
MDS™ Master Station
Enter this CLI command:
33