Front Panel - GE MDS Master Station Technical Manual

3. Once the list appears, it can be searched to locate the particular model you are seeking
information on. To the left of each entry, there is a document icon. Click the icon to display
the equipment authorization report.
4. Scroll down to the section labeled
designator. If additional assistance is required, contact GE MDS using the information given
at the end of this manual.

2.4 Front Panel

All access to Master Station modules is made from the front of the unit after removing the pro-
tective cover. To remove the cover, simply grasp the sides and pull out with a slight rocking mo-
tion. Tether strips on the ends of the cover are available to keep it linked to the chassis when it
has been removed from its installed position. The tethers allow the cover to rest just below the
front panel during service work.
Figure 2-2. MDS™ Master Station, Front Panel Connections & Indicators
(Representative arrangement; Module types vary based on product configuration)
Master Station modules are factory installed and cabled. All modules are installed on slide-in
assemblies and secured to the chassis with knurled fasteners. The illustration below shows the
modules installed in a redundant configuration. For a non-redundant configuration, blank plates
are used in place of the redundant power supply and radio modules, and a non-redundant version
of the Alarm/Relay module will be installed. The table that follows lists the module types availa-
ble as of the date of publication.
16
Equipment Specifications
MDS™ Master Station
to locate the appropriate emission
MDS 05-6399A01, Rev. E