Advertisement
GEO Storm 1990-93
ISUZU Impulse 1990-93 / Stylus 1991-93
(if keeping the factory pocket is NOT desired)
1
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the ashtray and the (2) outermost screws
exposed in the ashtray cavity. Remove (2)
screws from each side of the dash console.
Remove the climate control knobs. Unclip
the radio trim bezel. Remove (4) screws
from the metal console support. Remove
the factory head unit assembly and
disconnect the wiring. Remove (4) screws
securing the factory spacer plate to the radio
brackets and remove the plate.
3
"A"
Mount the converted Brackets to the Radio Housing with (6) #6 Phillips Screws supplied.
Slide the factory spacer plate onto the Brackets and mount through holes "A" with (2) Phillips
Screws supplied. Skip to the Installation Instructions for ALL VEHICLES on Page #7.
3
2
"C"
"C"
"C"
"C"
Cut and remove all mounting tabs on
Brackets Set #2 EXCEPT tabs "C". The
mounting tabs can be identified by the
stamped letter on the back of each tab.
"A"
GEO Storm 1990-93
ISUZU Impulse 1990-92 / Stylus 1991-93
(if keeping the factory pocket is desired)
1
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the ashtray and the (2) outermost screws
exposed in the ashtray cavity. Remove (2)
screws from each side of the dash console.
Remove the climate control knobs. Unclip
the radio trim bezel. Remove (4) screws
from the metal console support. Remove
the factory head unit assembly and
disconnect the wiring. Remove (4) screws
securing the factory spacer plate to the radio
brackets and remove the plate.
3
"A"
"B"
Using the v-cut as a guide, cut and remove the bottom portion of the Radio Housing. Mount
the Brackets to the Housing with (4) #6 Phillips Screws supplied. Mount the factory pocket to
the Brackets through holes "A" with (4) #8 Phillips Screws supplied. (It may be necessary to
trim the top and bottom edges of the pocket for a proper fit). Slide the factory spacer plate onto
the Brackets and mount through holes "B" with (2) Phillips screws and (2) Speed Clips
supplied. Skip to the Installation Instructions for ALL VEHICLES on Page #7.
2
"C"
"C"
"C"
"C"
Cut and remove all mounting tabs on
Brackets Set #2 EXCEPT tabs "C". The
mounting tabs can be identified by the
stamped letter on the back of each tab.
"A"
"B"
4
Advertisement
