Roland Camm-1 CX-24/12 User Manual page 45

WEIGHT| <LIGHT>
CALL| <USER1>
RESTORE| <USER1>
I/O | <AUTO>
Yes
Stored in Memory
LIGHT
Factry Default
LIGHT, HEAVY
Selection Choices
Sets the weight of the material. If material feed is not performed smoothly,
Description
set this switch to [HEAVY].
When set to [HEAVY], the upper limit for the cutting speed is set at 10 cm/
sec., and the force used to move the material and the blade increases. This
should normally be set to [LIGHT].
Yes
Stored in Memory
USER1
Factry Default
USER1 to 8
Selection Choices
This calls up the setting values stored using [RESTORE].
Description
Yes
Stored in Memory
USER1
Factry Default
USER1 to 8
Selection Choices
This stores the setting values for the respective menu items that are now
Description
being used.
The menu items that you can register are as follows.
FORCE, SPEED, OFFSET, and WEIGHT
Yes
Stored in Memory
You can call up stored setting by using [CALL].
AUTO
Factry Default
AUTO, PARA, SERIAL
Selection Choices
This specifies the type of interface for connection to the computer.
Description
AUTO
This selects the port automatically. The communication parameters for a
serial connection are set according to the settings made on the CX-24/12.
If the interface is not recognized correctly when set to AUTO, use the menu
to choose the type of interface you're using.
PARA (PARALLEL)
Choose this when connected to the computer using a parallel cable.
SERIAL
Choose this when connected to the computer using a serial cable.
45
9 Display Menu Descriptions