Roland Camm-1 CX-24/12 User Manual page 43

FORCE | < 50g>
SPEED |<40cm/s>
OFFSET| <0.250>
AREA |< 1.0m>
Yes
Stored in Memory
50 g
Factry Default
30 to 200 g
Setting Range
10 g
Steps
This sets the blade force used when cutting material.
Description
Perform a cutting test and set the conditions to match the loaded material and
the installed cutter.
Yes
Stored in Memory
40 cm/s
Factry Default
1 to 40 cm/s
Setting Range
1 cm/s when in the range of 1 to 10 cm/s
Steps
5 cm/s when in the range of 10 to 40 cm/s
This sets the speed used when cutting material.
Description
Set this to a suitable value for the loaded material and installed blade.
Yes
Stored in Memory
0.250 mm
Factry Default
0 mm (PEN), 0.175 mm, 0.250 mm, 0.500 mm
Selection Choices
This sets the amount of offset for the tip of the blade.
Description
Set a value that matches the conditions for the blade installed.
When using the included test material and blade or equivalent parts, cutting
can be performed using the factory-default settings.
Yes
Stored in Memory
1.0 m
Factry Default
-24.9 to 24.9 m
Selection Choices
This ensures that the material will not come loose during cutting by feeding
Description
out the length of material to be cut before actually performing cutting.
When performing continuous cutting on the same material, this can also be
used to make sure that there is enough remaining material to cut the data that
will be sent.
43
9 Display Menu Descriptions