Getting Ready for Recutting
Repeating cutting without replacing the material
1
Use the position keys to move the blade holder to the
location for setting a new origin point.
2
Press the [ORIGIN] key to set the origin point.
Repeating cutting on different material
1
Turn the dial to display the screen shown at right.
Press the [MENU/PARAM] key.
2
Turn the dial to display the screen shown at right.
Press the [ENTER] key.
The setup state is released.
3
Load the new material. For information on how to
load the material, see
Performing Recutting
1
Turn the dial to display the screen shown at right.
Press the [MENU/PARAM] key.
2
Press the [ENTER] key.
Recutting starts.
"4-2 Loading the
Material."
SETUP |
<ON>
SETUP |
ON->OFF
REPLOT|
START
REPLOT|
START
37
7 Repeating the Same Cutting