Daikin EWAQ016CAW Installation And Operation Manual page 33

Result: If is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored, but action 4 is deleted. You
automatically return to step 6. Press
to previous steps in this procedure and finally return to normal
operation.
13 You automatically return to step 6; start again to program the
following day.
To program space heating
5 sec
INFORMATION
Press to return to previous steps in the programming
procedure without saving modified settings.
1 Press to enter the programming/consulting mode.
2 Select the operation mode you would like to program using
and .
Result: The actual mode is blinking.
3 Press to confirm the selected mode.
EWAQ016~064CAW + EWYQ016~064CAW
Packaged air-cooled water chiller
4P489435-1B – 2017.10
4 Select the day you would like to consult or to program using
several times to return
5 Press
6 Hold down
7 Select the action number you would like to program or to modify
8 Set the correct action time using
9 Set the leaving water temperature using
10 Set the room temperature using
11 Press
12 Set the appropriate shift value using
13 Repeat this procedure to program the other actions of the
14 Press
15 You automatically return to step 6; start again to program the
To program quiet mode
5 sec
Result: The actual day is blinking.
and .
Result: The selected day is blinking.
to confirm the selected day.
for 5 seconds to program the detailed actions.
Result: The first programmed action of the selected day
appears.
using .
to select:
▪ : to switch heating and the remote controller off.
▪ : to select automatic temperature calculation for leaving
water temperature
more information about weather dependent setpoint, see
"12.3.6 Schedule timer" on page 30.
selected day.
Result: When all actions have been programmed, make sure
that the display shows the highest action number you would like
to save.
for 5 seconds to store the programmed actions.
Result: If is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored, but action 4 is deleted. You
automatically return to step 6. Press
to previous steps in this procedure and finally return to normal
operation.
following day.
12 Operation
and .
and .
and .
and . For
several times to return
Installation and operation manual
33