Autopilot Control - Advanced Settings - Raymarine AXIOM Advanced Operation Instructions

5.2 Autopilot Control — Advanced settings
Menu item Description
Vessel hull type Selecting the hull type that is the closest match
for your vessel provides optimum steering
performance.
Selecting the drive type that matches your
Drive type
vessel's drive will provide optimum drive
performance.
Compass offset Adjust the Compass offset so that your
autopilot's heading matches the ship's
compass.
The display of autopilot heading data requires
a second networked MFD or pilot controller.
Compass offset will be adjusted automatically
during the Align compass to GPS procedure.
Selects the source for speed data.
Speed input (1)
Cruise speed Set the Cruise speed value to your vessel's
(1)
typical cruising speed.
Calibration lock The calibration lock is used to lock out specific
calibration settings which if changed may
require recommissioning of the autopilot
system. If your system has been dealer
installed then the lock may be turned on.
Dockside calibration must be carried out
Dockside wizard
before using your autopilot for the first time.
The Dockside wizard guides you through the
dockside calibration process.
The steps included in the dockside wizard are
dependent on whether you have a rudder
reference transducer fitted to your vessel.
Restart compass
Select to restart the compass linearization
procedure.
Compass lock Locks the compass linearization so that further
automatic linearization is not performed.
Follow the onscreen instructions to align your
Align compass to
compass with your GPS heading.
GPS (1)
Pilot factory reset Resets your autopilot's settings to factory
default values.
CCU debug level (1) Sets a debug value for troubleshooting
purposes.
The debug level should only be set when
requested by Technical Support as part of a
troubleshooting process.
54
Options
• Sail
• Sail (slow turn)
• Sail Catamaran
• Power
• Power (slow turn)
• Power (fast turn)
List of drives compatible with
your ACU.
• -10° to +10°
• 0° (default)
• Auto (default)
• Water speed (STW)
• SOG
• Default cruise speed
• 4.0kts to 60.0kts
• On
• Off
• Drive type
• Rudder limit
• Align rudder
• Hard over time
• Rudder drive check
• Start
• Cancel
• On
• Off
• Yes
• No
• 0 to 63