Connecting To A Wireless Display; Disconnecting A Wireless Display - Raymarine AXIOM Advanced Operation Instructions

4.11 Connecting to a wireless display

Your MFD can be connected to a wireless display using an external dongle or a display that has
built-in support. When connected the MFDs screen is mirrored on the wireless display.
1. Follow the instructions provided with your wireless display/dongle to set up the device.
2. Select the display icon found under Wireless display: on the This Display tab of the Settings
menu: (Homescreen > This Display > Wireless Display:).
Your MFD will search for available displays.
3. Select the display you want to use.
4. If your MFD has Wi-Fi Sharing enabled then a pin number is displayed on the wireless display,
input this pin number when requested by your MFD.
5. You may also be requested to allow the MFD to connect automatically in future, select Yes or
No as appropriate on your wireless display.
Your MFD screen will now be displayed on the select device.
6. To allow the wireless display to connect each time your MFD is powered on, then enable Connect
on power up from the pop-over options.
Note:
1. Don't forget to check your wireless display for any required confirmations/acknowledgements.
2. Some non Miracast certified devices may not be able to connect with Wi-Fi Sharing enabled, in
this case disable Wi-Fi Sharing and try again.
3. If you experience issues connecting try disabling and enabling the wireless display feature on
your display and MFD or power cycle both devices.
4. Once connected/paired to a wireless display do not change your MFD's Wi-Fi Passphrase as
on certain devices a factory reset maybe required to re-establish a connection.

Disconnecting a wireless display

With a wireless display connection active:
1. Select Disconnect from the This Display tab: (Homescreen > Settings > This Display > Wireless
Display: > Disconnect).
46