Table of Contents
Advertisement
This equipment complies with FCC and IC RSS-
102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should
be installed and operated with minimum distance
6" (7.87inch(20cm)) between the radiator & your
body.Any changes or modifications not expressly
approved by the manufacturer could void
This device complies with Industry Canada
licenceexempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause harmful interference and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This Class B digital apparatus complies with
Canadian ICES-003
When installing the outdoor unit at the seaside,
make sure that it is not directly exposed to sea
breeze. If you cannot find an adequate place free
from direct sea breeze, construct a protection wall
or a protective fence.
– Install the outdoor unit in a place (such as
near buildings etc.) where it can be protected
from sea breeze. Failure to do so may cause a
damage to the outdoor unit.
Sea breeze
Outdoor unit
Sea
If you cannot avoid installing the outdoor unit at
the seaside, construct a protection wall around to
block the sea breeze.
Construct a protection wall with a solid material
such as concrete to block the sea breeze. Make
sure that the height and the width of the wall are
1.5 times larger than the size of the outdoor unit.
Also, secure a space larger than 23.6inch(600 mm)
between the protection wall and the outdoor unit
for exhausted air to ventilate.
Sea breeze
Sea
Install the unit in a place where water can drain
smoothly.
IBIM_EN.indd 35
Sea breeze
Outdoor unit
Sea
Protection wall
Outdoor unit
Outdoor unit
Protection wall
If you have any difficulty finding installation
location as prescribed above, contact your
manufacturer for details.
Be sure to clean the sea water and the dust on the
heat exchanger of the outdoor unit and apply a
corrosion inhibitor on it. (At least once in a year.)
Power supply line, fuse, or circuit
breaker
Always make sure that the power supply is
compliant with current safety standards. Always
install the air conditioner in compliance with
current local safety standards.
Always verify that a suitable grounding connection
is available.
Verify that the voltage and frequency of the
power supply comply with the specifications and
that the installed power is sufficient to ensure
the operation of any other domestic appliance
connected to the same electric lines.
Always verify that the cut-off and protection
switches are suitably dimensioned.
Verify that the air conditioner is connected to the
power supply in accordance with the instructions
provided in the wiring diagram included in the
manual.
Always verify that electric connections (cable
entry, section of leads, protections...) are
compliant with the electric specifications and with
the instructions provided in the wiring scheme.
Always verify that all connections comply with
the standards applicable to the installation of air
conditioners.
Be sure not to perform power cable modification,
extension wiring, and multiple wire connection.
– It may cause electric shock or fire due to poor
connection, poor insulation, or current limit
override.
– When extension wiring is required due
to power line damage, refer to "Step 2.4
Optional: Extending the power cable" in the
installation manual.
English
35
3/17/2017 10:01:14 AM
Advertisement
Table of Contents
