Status Indicator - Panasonic WV-S6131 Important Information Manual

③Status indicator

Operation status
When the power Before the network connection
is turned on is established
When the network connection
is established
During the standby Cable is not connected
or connection
Cable is connected
During the upgrade process
Initialization (When the network connection is
established)
Port forwarding error caused by the UPnP function Blinks orange (in 2 seconds intervals
Trouble happening on the camera
Failure in writing data on the SD memory card
Note:
• Lighting/blinking LED can be turned off with the software settings at any time. (The initial state
is lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation
conditions. (☞ Operating instructions included in the CD-ROM)
• When the power is on, initialization may start with orange blinking.
④SD ON/OFF button
⑴ When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the SD memory card.
⑵ W hen the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the SD memory card can be removed.
Indicator status
Lights orange → Lights off → Blinks orange →
Lights orange
Lights orange → Lights off → Blinks orange →
Blinks green → Lights green
Lights orange
Lights green
Blinks orange
Lights orange → Lights off → Blinks orange →
Lights orange → Blinks orange → Blinks green
→ Lights green
(on for 1 second / off for 1 second))
Blinks red
Lights red
24