Panasonic WV-S6131 Important Information Manual page 11

S6130
Do not touch the dome cover with your
bare hands.
A dirty dome cover causes deterioration of pic-
ture quality.
When an error is detected, this product
will restart automatically.
This product will be inoperable for around 2
minutes after the restart just as when the
power is turned on.
About the automatic status detection
function
When this product malfunctions due to exoge-
nous noise, etc. for 30 seconds or more, the
product will automatically reset and will return to
normal state. When the product is reset, initializa-
tion will be carried out as when the power of the
product is turned on. When the product repeat-
edly resets, exogenous noise level around the
product may be high and that may cause mal-
function. Contact your dealer for instructions.
Periodically images on the screen appear
to be distorted
When the camera is installed in a location where
it is subject to small vibrations (for example,
when it is installed near devices that vibrate),
images may appear distorted and stretched
lengthways. This phenomenon is a characteris-
tic of image pickup devices that use MOS sen-
sors and is caused by the relationship between
the periodic movements of the camera and the
timing that the image sensor reads images. This
is not a problem with the camera. To reduce the
possibility of this phenomenon occurring, install
the camera in a secure location.
We shall not be liable for content
compensation, losses of recorded or
edited content and any direct or indirect
consequent damages caused by failure to
record or edit due to faults with this unit or
the SD memory card. In addition, the same
provisions apply after unit is reparied.
About the MOS image sensor
• When continuously shooting a bright light
source such as a spotlight, the color filter
of the MOS image sensor may become
deteriorated and this may cause discolor-
ation. Even when changing the fixed
shooting direction after continuously
shooting a spotlight for a certain period,
the discoloration may remain.
• When shooting fast-moving subjects or
objects crossing the shooting area may
look to be bending askew.
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury. Do not
use benzine, thinner, alcohol, or any other
types of solvents or detergents. Otherwise, it
may cause discoloration. When using a chemi-
cal cloth for cleaning, read the caution provid-
ed with the chemical cloth product.
* Do not loozen or remove screws unless
instructed to do so in the product documen-
tation.
* The camera position may be moved inadver-
tently while cleaning the camera body. Restart
the camera or refresh the camera position (posi-
tion refresh) to correct the camera position.
Refer to the Operating Instructions (included in
the CD-ROM) for further information.
S6131 S6111
Cleaning the lens
Use a lens cleaning paper (used to clean cam-
era lenses or lenses of spectacles). When using
solvent, use an alcohols solvent and do not
use a thinner or a glass cleaner.
S6130
Cleaning of the dome cover
Use lens cleaning paper (used to clean camera
or spectacles lenses) to remove any dirt on the
dome cover.
About the stabilizer function
Depending on the conditions in the installation
area, effects of the stabilizer function may not
be fully achieved.
11