Tuner Operation - Jensen JWM10A Owner's Manual

Auxiliary Input Connector
For front panel audio input, an external audio source can be connected with a
3.5mm audio cable adapter. Connect the device to the AUX IN connector(6) on
the front panel. In addition to front panel auxiliary input source, the external audio
source can also be connected to the RCA audio input
through the AUX AUDIO INPUT jack
on the rear of the unit.
Clock Display
Press the VIEW/SET button (8) to alternate the display between Playback mode
and clock time while in Tuner, Bluetooth or auxiliary input mode.
Clock Setup
Press and hold the VIEW/SET button (8) to access Clock Setup mode. The
number representing the hours and minutes will flash. Press VOLUME
buttons to adjust the hour. Press the VOLUME
The new time will be saved 5 seconds after the last adjustment is made.
Zone Output
The two zone output buttons (11)/(12) (ZONE A and ZONE B) control zone output
from the radio. Press any of the two buttons to turn the corresponding speaker
sets on or off.

TUNER OPERATION

Select a Band
Press BAND/ ENTER(7) to change between three FM bands (FM1, FM2 and FM3)
and two AM bands (AM1 and AM2).
Manual Tuning
H
Press the tune up(15) or tune down(13) buttons to tune the frequency one step
buttons to adjust the minutes.
M
higher or lower. Press and hold to seek tune to next strong station.
Preset Stations
Six numbered preset buttons store and recall stations for each AM and FM band.
Select a band (if needed), then select a station. Hold a preset button for one second.
The current station will be stored, and the corresponding preset number will appear
in the display.
Select a band (if needed). Press a preset button momentarily, and the unit will tune to
the corresponding stored station.
Automatically Store Automatically Store / Preset Scan (AS/PS)
7
1
2
3
H M
4
5
6
7
10 11
8 9
Store Preset Stations
Recall Preset Stations
Automatically Store
Press and hold the AS/PS button (5) for more than one second, and the unit will
automatically scan for and store six strong stations for all bands. To stop this function
before the automatic storing is complete, press AS/PS again.
Preset Scan
Press AS/PS to scan all preset stations in the current band. The unit will play each
station for five seconds before moving on to the next station. To stop this function and
play the current station, press the AS/PS button again.
JWM10A
13 14 15
12