Tuner Operation - Jensen JWM9ABK Installation And Operation Manual

TUNER OPERATION

Select a Band
Press SOURCE button (10), the LCD will display "MODE" and enter mode selection.
1.
2. Press SOURCE button to navigate the available modes and choose radio mode.
3. Press ENTER button (12) to confirm the selection of radio mode.
4. Then, press SOURCE button to select the band (AM1, AM2, FM1, FM2 and FM3). Press
ENTER button (12) to confirm the selection of radio mode.
Manual Tuning
Press the >>| or |<< buttons (14, 13) to seek stations up/down step by step.
Auto Seek Tuning
Press and hold the >>| or |<< buttons (14, 13) to automatically seek the next or previous strong
station.
Preset Stations
Six numbered preset buttons store and recall stations for each AM and FM band.
Store a Station
Select a band (if needed), then select a station. Press and hold a 1-6 preset button for two
seconds. The present number will appear on the display.
Recall a Station
Select a band (if needed). Press a 1-6 preset button to select the corresponding stored station.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select an AM or FM band. Press and hold the AS/PS button (8) for more than 3 seconds and the
unit will automatically scan for and store 12 or 18 strongest stations for AM or FM respectively.
To stop this function before the automatic storing is complete, press AS/PS again.
Preset Scan
Select a band. Press AS/PS button to scan stations stored in the current band. The unit will
pause for 10 seconds at each preset station. Press AS/PS again to stop scanning when the
desired station is reached.
8
JWM9A