Checking The Oil Level Of The Hydraulic Durch; Adjusting The Idle Speed; Check Transmision Oil Level; Changing The Transmission Oil - KTM 125 EXE 2001 Owner's Handbook Manual

2
1
3
4
5
6
7
8
Checking the oil level of the hydraulic clutch
To check the oil level in the master cylinder of the clutch remove the cover.
For this purpose, remove screws
boot 3 . The oil level in the horizontal-standing master cylinder should be
4 mm below the upper edge. If necessary add SAE 10 hydraulic oil
!
O SAE 10
NLY USE MINERAL HYDRAULIC OIL
. N
THE MASTER CYLINDER EVER USE BRAKE FLUID

Adjusting the idle speed *

The idle speed can be adjusted with idle screw
Turning in clockwise direction will increase the idle speed.
Turning in counter-clockwise direction will reduce the idle speed.
Check transmission oil level
In order to check the transmission oil level the control screw
clutch cover is to be removed. Oil should just barely escape from the ins-
pection opening when the motorcycle is in an upright position. If necessary,
6
remove the plug and top up with gear oil SAE-80W (i. e. Shell Advance
Gear EP).
!
T
RANSMISSION AND CLUTCH WILL BE SUBJECT TO AXCESSIVE WEAR AND TEAR
USE TOO LITTLE OR LOW GRADE OIL
Gear EP).

Changing the transmission oil *

To change the gear oil warm up the engine and park the motorcycle on a
horizontal surface. Remove oil drain plugs
into an appropriate container. Clean the magnets of the oil drain plugs and
mount them together with the appropriate gaskets. Fill in 0.7 l gear oil
SAE-80W (i. e. Shell Advance Gear EP), mount the plug
engine for leaks.
!
T
RANSMISSION AND CLUTCH WILL BE SUBJECT TO AXCESSIVE WEAR AND TEAR
USE TOO LITTLE OR LOW GRADE OIL
Gear EP).
1 2
and cover together with the rubber
CAUTION
(i.e. Shell Naturelle HF-E15)
!
4
.
CAUTION
. U - (i. e. Shell Advance
SE ONLY HIGH GRADE OIL
7 8
and and drain the used oil
6
CAUTION
. U - (i. e. Shell Advance
SE ONLY HIGH GRADE OIL
!
TO REFILL
27
5
on the
!
,
IF YOU
and check the
!
,
IF YOU