Checking The Oil Level Of The Hydraulic Clutch; Bleeding Of The Hydraulic Clutch - KTM 950 ADVENTURE 2003 Manual

2-9
2

Checking the oil level of the hydraulic clutch

To check the oil level in the master cylinder of the clutch remove the
cover. For this purpose, remove bolts and cover together with the rubber
1
1
boot . The oil level in the horizontal-standing master cylinder should
be 4 mm below the upper edge. If necessary add SAE 10 biodegradable
hydraulic oil (e.g. Motorex Kupplungs-Fluid 75).
O
NLY USE
.
CYLINDER
MINERAL OILS

Bleeding of the hydraulic clutch

For bleeding, the cover of the master cylinder of the clutch needs to be
removed. For this purpose, remove bolts and take off cover together
with rubber bellows
bleeder nipple. At its place, mount the bleeder syringe
with biodegradable hydraulic oil (e.g. Motorex Kupplungs-Fluid 75).
Refill oil, until oil is discharged from the bore
a bubble-free state. Make sure that the oil does not overflow.
H
AVING COMPLETED THE BLEEDING PROCEDURE
LEVEL IN THE MASTER CYLINDER IS CORRECT
SAE 10
USE
A
F 75);
LUID
MINERAL OILS
! CAUTION
SAE 10
BIODEGRADABLE HYDRAULIC OIL TO REFILL THE MASTER
NEVER USE BRAKE FLUID NOR MIX BIODEGRADABLE HYDRAULIC OILS WITH
!
1
. At the slave cylinder of the clutch, remove the
! CAUTION
BIODEGRADABLE HYDRAULIC OIL ONLY
NEVER USE BRAKE FLUID NOR MIX BIODEGRADABLE HYDRAULIC OILS WITH
.
!
2
which is filled
A
of the master cylinder in
!
,
YOU HAVE TO VERIFY THAT THE OIL
.
FOR FILLING OF THE MASTER CYLINDER
( . M K
EX OTOREX UPPLUNGS
,
-