Fluke PM6690 Operator's Manual page 29

The following can be done:
•
Save current setup
Fig. 2-24 Selecting memory position for
saving a measurement setup.
Browse through the available memory
positions by using the
arrow keys. For faster browsing, press
Next
the key to skip to the next memory
bank. Press the softkey below the num-
ber (1-20) where you want to save the
setting.
•
Recall setup
Fig. 2-25 Selecting memory position for
recalling a measurement setup.
Select the memory position from which
you want to retrieve the contents in the
same way as under Save current setup
above. You can also choose Default to
restore the preprogrammed factory set-
tings. See the table on page 2-15 for a
complete list of these settings.
•
Modify labels
Select a memory position to which you
want to assign a label. See the descrip-
tions under Save/Recall setup above.
Now you can enter alphanumeric char-
acters from the front panel. See the fig-
ure below.
The seven softkeys below the display
are used for entering letters and digits in
the same way as you write SMS mes-
sages on a cell phone.
RIGHT/LEFT
•
Setup protection
Toggle the softkey to switch between
ON/OFF
the modes. When
tive, the memory positions 1-10 are all
protected against accidental overwriting.
Fig. 2-26 Entering alphanumeric charac-
ters.
Calibrate Menu
This menu entry is accessible only for calibra-
tion purposes and is password-protected.
Interface Menu
Fig. 2-27 Selecting active bus interface.
Bus Type
Select the active bus interface. The alterna-
tives are GPIB and USB. If you select GPIB,
you are also supposed to select the GPIB
Mode and the GPIB Address. See the next two
paragraphs.
Description of Keys 2-13
Using the Controls
ON
is ac-