Quick Start; Unpacking; Set Up - Fluke 7012 User Manual

4

Quick Start

CAUTION: READ SECTION 6 ENTITLED "BATH USE" before placing
the bath in service. Incorrect handling can damage the bath and void the
warranty.
This section gives a brief summary of the steps required to set up and operate
the 7012 bath. This should be used as a general overview and reference and not
as a substitute for the remainder of the manual. Please read Section 5 through 7
carefully before operating the bath.
4.1

Unpacking

Unpack the bath carefully and inspect it for any damage that may have oc-
curred during shipment. If there is shipping damage, notify the carrier
immediately.
Verify that all components are present:
• 7012 Bath
• Controller Probe
• Access Hole Cover
• User's Guide
• Report of TEst
• Fill Hole Cover
• Drain Elbow
If you are missing any item, please contact an Authorized Service Center.
4.2

Set Up

Set up of the bath requires careful unpacking and placement of the bath, filling
the bath with fluid, installing the probe and connecting power. Consult Section
5 for detailed instructions for proper installation of the bath. Be sure to place
the bath in a safe, clean and level location.
Fill the bath tank with an appropriate liquid. For operation at moderate bath
temperatures, clean distilled water works well. Carefully pour the fluid into the
bath tank through the large rectangular access hole above the tank avoiding
spilling any fluid. The fluid must not exceed a height of 1/2 inch below the bath
lid.
The control probe must be inserted through the lid into the bath and plugged
into the socket at the back of the bath.
4 Quick Start
Unpacking
13