Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Power Plate Pro 5
Summary of Contents for Power Plate Pro 5
- Page 1 ® Pro 5 SSEMBLY NSTRUCTIONS...
- Page 2 Assembly and Setup Unpacking The Pro 5 Power Plate is shipped in 2 boxes. Remove all parts from both shipping boxes and verify that the following parts were included in your shipment: Platform Box: Description Qty. Platform Assembly Power Cord...
- Page 3 2. Insert the White Foam Diamond Inserts into the vibration rubbers in the platform as shown. If not in a carpeted area, please make sure the platform is protected while on its top surface. Step 2 3. Gently lower the vibrating platform on top of the steel plate of the column in the position where the Black Motor cable on the vibrating platform is in position to attach to its connection on the steel plate of the vertical column, and the yellow ground wire is also in position to attach to the ground...
- Page 4 4. Reach under the vibrating plate and secure Black Motor Cable to its connector. The black cord will only go in ONE way then screw to fix permanent seal. Then attach yellow/green ground wire after. Tip- Once the vibrating platform is in position over the steel plate, •...
- Page 5 6. Finally, attach the 4 feet. *Please note – the 2 Rubber Post shaped feet (pic. 1) are attached to the front of the plate, while the 2 Suction Cup shaped feet (pic. 2) are attached to the back of the platform. The feet are threaded;...
- Page 6 7. You are done. Connect the black power cord to the back of the machine and wall. The On / Off Switch is located on the lower back of column, turn to I for “on” and O for “off”. Tip- Please secure Power Cord tightly to the back of the column, as •...
- Page 7 Completed Assembly For any further assembly or installation questions, please call Power Plate North America, Inc. at 847-509-6000.
Need help?
Do you have a question about the Pro 5 and is the answer not in the manual?
Questions and answers