Installer System Test - Honeywell T6 Pro Hydronic Installation Instructions Manual

Installer system test

To perform a System Test:
1 Press and hold CENTER and
approximately 3 seconds to enter advanced
menu.
to go to TEST. Press Select to enter
2 Use
System Test.
3 Use to change between Heat or Ver
(thermostat version information). Press Select.
4 Press to turn heat on. Press
off.
5 Use the Home button to exit the System Test.
Alerts
Active alerts are displayed via the alert
area on the home screen. You can read more information about active alerts,
snooze or dismiss non-critical alerts in MENU/ALRT.
Number Alert/Reminder
170 Internal Memory Error
171 Set the Date and Time
173 Thermostat Temperature
Sensor Error
177 Indoor Temperature Sensor
Error
252 AC Power Lost
405 Battery Low
407 Battery Critical
514 Floor Temperature Sensor
Failure
535 High Floor Temperature
536 Freeze Protection
buttons for
to turn heat
symbol and alert number in the clock
Definition
The memory of the thermostat has encountered an error. Please contact dealer for
assistance.
Set the date and time on your thermostat. The date and time are required for certain
features to operate, like the program schedule.
The sensor of the thermostat has encountered an error. Please contact dealer to replace
the Thermostat.
Wired indoor temperature sensor is not connected or there is a wiring short. Please
contact dealer for assistance.
No AC power detected. Please check the AC circuit breaker.
Battery low. Please turn the system mode to off and replace the batteries.
Battery critical. Thermostat cannot control your system. Please replace the batteries
immediately.
Wired floor temperature sensor is not connected or there is a wiring short. When
the thermostat has been configured for AF mode, the thermostat will still control
the ambient air temperature but will ignore the floor temperature limits. When the
thermostat has been configured to F mode, heating will stop. However, when the air
temperature drops to, or below freeze protection temperature limit, heating will be
activated and control the ambient air temperature.
The measured temperature is above maximum floor temperature limit.
The measured temperature is below freeze protection temperature limit.
10