Setting Current Day And Time; Installer System Test - Honeywell T7300E Series Installation Instructions Manual

T7300E SERIES 2000 COMMERCIAL MICROELECTRONIC HEAT PUMP THERMOSTAT
Installer
Setup Number
(Press
Unoccupied
Temp key
to change)
Select
Minimum off 38
times in heating
Not used 39
Installer Setup 40
lockout (keypad
lockout is
enabled and
disabled by DIP
switch 1 on back
of thermostat)
IMPORTANT
Review the settings to confirm that they match
the system. Press Run Program to exit the
Installer Setup. Be sure to set the current day
and time immediately.

Setting Current Day and Time

1. Press Set Current Day/Time.
NOTE: On initial power up or after an extended
power loss, 1:00 pm flashes on the LCD
until a key is pressed.
Set Current
Day/Time Set Program
Run Occupied Unoccupied
Program Start Time Start Time
Temporary Set Current Clear
Occupied Day/Time Start Time
Continous
Unoccupied
2. Press Day until the current day is displayed.
NOTE: Sun=Sunday, Mon=Monday,
Tue=Tuesday, Wed=Wednesday,
Thu=Thursday, Fri=Friday, Sat=Saturday.
Day
Set Program
Run Occupied Unoccupied
Program Start Time Start Time
Temporary Set Current Clear
Occupied Day/Time Start Time
Continous
Unoccupied
3. Press increase
time is displayed.
NOTE: Tapping the Set Current Day/Time will
change the time in one hour increments.
Set Program
Run Occupied Unoccupied
Program Start Time Start Time
Temporary Set Current Clear
Occupied Day/Time Start Time
Continous
Unoccupied
Table 2. Thermostat Installer Setup Options (Continued).
Factory-Setting
Display
4 4—4 minute minimum
off time
—
0 0—No Installer Setup
lockout
Set Day/Time
PM
Set Temperature Change
Time/Temp
Occupied Unoccupied
Day Temp Temp Mon
Heat/Cool
Copy Settings
System Fan
Set Day/Time
PM
Set Temperature Change
Time/Temp
Occupied Unoccupied
Day Temp Temp Tue
Heat/Cool
Copy Settings
System Fan
or decrease until the current
Set Day/Time
PM
Set Temperature Change
Time/Temp
Occupied Unoccupied
Day Temp Temp
Tue
Heat/Cool
Copy Settings
System Fan
(Press
Description Display
0, 1, 2, 3,
or 5
— —
1
4. Press Run Program.
Run
Program

INSTALLER SYSTEM TEST

Use the Installer SystemTest to check the thermostat
configurations and operation. Refer to Table 3 for a list of
the available system tests.
Table 3. Tests Available in Installer System Test
Test
M4951B
Number
10 to 19 Heating equipment can be turned on and off
20 to 29 Emergency heat equipment can be turned
on and off
30 to 39 Cooling equipment can be turned on and off
40 to 49 Fan equipment can be turned on and off
60 0 to Keyboard keys test
60 19
70 to 79 Thermostat information including date code,
software versions and subbase identification
M4952B
are displayed
M4953B
5
Other Choices
or key to change)
Description
Minimum number of minutes
(0 thru 5) the heating
equipment will be off
between calls for heat
—
1—Installer Setup lockout
activated
Set Program Set Temperature Change
Time/Temp
Run Occupied Unoccupied Occupied Unoccupied
Program Start Time Start Time Day Temp Temp
Mon
Occupied 1
Temporary Set Current Clear Heat/Cool
Occupied Day/Time Start Time Copy Settings
System
Continous
Unoccupied System Fan
Heat
System Test Description
Actual
Setting
—
AM
Room
Fan
Auto
M4954A
(Continued)
62-0124—3