Repair Flow - Philips 2000 PURO/VAPORE Service Manual

PHI 2000 PURO/VAPORE

6.1. Repair Flow

Proces stap
Intake
Diagnosis
Repair
Inspection
visual
Power check
Accesoires
Consumer complaint
Coffee
Dispense
Saeco Action
no.
1 Visual inspection (transport damage) take care for pictures
2 Check Type/serialnumber
Log all available accessory
3 Check product for consumer complaint (NFF contact consu-
mer)
4 Opening machine
5 Visual inspection check for loosen parts, leaking etc..
6 Operational tests
Run Diagnostic to get error codes and relevant set statistics
(Saeco Service Center SSC)
7 Repairing the faults encountered
8 "Checking any modifications (view Symptom Cure, new
software, etc.)
Refer Annex tabs per family"
9 Service activities in accordance with the operating schedule
Check/Replace Waterfilter (the small filter, not the Britta filter)
Check/Replace Water tank lip seal
Check/Replace Boiler pin O-ring
Clean/align Coffee grinder (Vacuum cleaner / brush)
Descale the water Circuit
Check/Replace Hot water/steam valve
10 Internal check / cleaning
Check/Clean/Grease Brewing unit
11 Operational test while the appliance is open
Check Hoses, attachments and Oetiker clamps
Check Pump for operation & noise
Check Gear motor for operation & noise
Check for leakage
12 Assembly
13 Final inspection test
14 Steam out before shipping out, if temperature is below 0° to
prevent any demaged due to frozen water
Do cabinet parts fit well together
Check for damages
Will the set switch on
Do the accessories match with the intake
Check the product for the consumer complaint
Make 2 * coffee. Are both amounts equal
Make e 2 cups at the same time. Are the volumes equal
06 SERVICING AND MAINTENANCE
1/2