Test Mode Phi 2000 Vapore - Philips 2000 PURO/VAPORE Service Manual

PHI 2000 PURO/VAPORE
5.2

Test Mode PHI 2000 Vapore

Double Coffee Led Short Coffee button
No water Led Long Coffee button
The machine enters in test mode by moving the knob in the Water position
then pushing the COFFEE short button
and then connecting the machine to the plug
As long as the COFFEE short button is pressing the machine shows the Led Calc-Clean, Led Activity,
Led Alarm, Led NoWater, Led DoubleCoffee, flashing with rotation.
When the COFFEE short button is release the machine pass to the first level of the test.
There are 4 different level, in each level the coffee-machine can execute different commands:
Level 1: The machine can test the input signal:
a) Microswitch present of the brewing unit
b) Microswitch present of the dregdrawer
c) Microswitch door closed/opened
d) Button Short Coffee
e) Button Long Coffee
f) Button ON-OFF
g) Photosensor Water
h) Photosensor Steam (only in Middle-TOP model)
Level 2: The machine can test the loads in low voltage:
a) Brewing unit (24V DC)
Level 3: The machine can test the Pump in high voltage:
a) Pump (120-230V AC)
Level 4: The machine can test the Heater load in high voltage:
a) Heater (120-230V AC)
Level 5: The machine can test the Grinder load in high voltage:
a) Grinder (320V DC)
Descaling Led
Alarm Led
Water Position
ON/OFF button
This document describes the test
mode of XS PH Vapore machine.
This application is used in order to
test the machine in its mechanics
and electronic components.
Activity Led
Water Position
05 SERVICE MODE
7/14