Table of Contents
Advertisement
MOLTIO
5.1.1. Test mode in Moltio One Touch Milk Carafe
To enter Test Mode
The machine enters Test Mode by holding pressed together Espresso and Stand-by while switching
on the machine by mean of the main switch on the backside of the machine. Once entered in Test
Mode, the display shows the firmware version.
The Test Mode is organized into 6 different pages :
(press CAPPUCCINO to move to the next screen)
Page 0: The display shows:
a) Firmware version.
b) Type.
c) "230"/"120" if the machine is a 230V or 120V model.
d) Main supply frequency (50 or 60 Hz).
Page 1: Keyboard and display's colour test:
a) Espresso button
b) Coffe button
c) Aroma button
d) Cappuccino button
e) Latte Macchiato button
g) Stand-by button
h) Menu button
Page 2: Input signals test:
a) Water level sensor
b) Microswitch door closed/opened
c) Microswitch presence of the Brew Unit
d) Microswitch presence of the Dregdrawer
e) Select the COM port between USCP and Freemaster
f) Lever position on Drip
Page 3: Low voltage loads test:
a) Brew Unit movement upward and downward (24V DC)
Page 4: High/Low voltage loads test (Pump, E.Valve ) :
a) Pump (120-230V AC)
b) Electro Valve two-way (24Vdc)
c) Electro Valve three-way (24dc)
Page 5: High voltage loads test (Heater, Grinder, Protection cover coffee beans ):
a) Heater (120-230V AC)
b) Grinder (170-320V DC)
c) Cover ON/OFF
Page 6: Values Autodose
a) Value Autodose for each selection of beans
One Touch
Milk Carafe
05 SERVICE MODE
1/13
Advertisement
Table of Contents
