Table of Contents
Advertisement
Mounting the DES-7210/7206 into the Cabinet
Verify the following before installation:
The cabinet has been fastened properly and various modules in the frame have been
installed. There should be no obstacles for installation in the frame and in the surrounding.
The equipment to be installed is ready, and has been moved to a place of easy handling and
close to the frame.
Simple Installation Steps:
1.
Levelly lift the DES-7210/7206 by two people on both sides, and slowly move it to the
front of the frame.
2.
Levelly lift the DES-7210/7206 to a position slightly higher than the tray or the slide rail
of the cabinet, put the equipment onto the tray or the slide rail, and push it into the
cabinet.
3.
Fasten the DES-7210/7206 onto the cabinet with screws. There are fastening notches
on both the left and right of the front panel on the equipment frame. Use screws to
fasten them to the fastening bracket of the cabinet. After fastened, the equipment
should be stable and still in the cabinet.
Installing the Fan Tray
The DES-7210/7206 provides a ventilation system, 7210-FAN for DES-7210, and 7206-FAN
for DES-7206. Install the fan tray by performing the following steps:
1.
Remove the blank panel of the fan tray by loosing the captive screws with a straight
screwdriver and the cross screws with a cross screwdriver.
2.
Push the fan into the cabinet along the guide rail.
3.
Tighten the captive screws with a straight screwdriver. Figure 3-1 and Figure 3-2 show
the installed fan tray.
8
Installing the Fan Tray of the DES-7210 and DES-7206
DES-7200 Series Quick Installation Guide
Advertisement
Table of Contents
