Table of Contents
Advertisement
DES-7200 Series Quick Installation Guide
Precautions
Before connecting the power supply, you must verify that the external power supply
provided matches the power module installed of this equipment.
Before connecting the power cable, you must make sure that the switch of the power
module is at the OFF position.
The power cables of various colors must be connected to the appropriate wiring posts.
You must ensure that the power cables connected are in good contact.
Simple Connection Steps
1.
Remove the protection cover of the DC wiring terminal.
2.
Lock the power cable to the appropriate terminal according to the identification, and
tighten the pressing screw.
3.
Put on the protection cover and tighten the screw.
4.
Connect the other end of the power cable to the corresponding socket or connector.
Connecting the AC Power Supply to the Power
Module
Connect the related AC power cable according to the ID on the panel of the AC power
module and the location requirement, as shown in the following diagram.
Schematic Diagram for the Connection of the DC Power Cable
13
Advertisement
Table of Contents
