Advertisement
Introduction and Features
This KVM extender allows you to connect consoles to computers via a distance of up to 130m for direct Cat.6
cable connection, or up to 200m via a gigabit network switch, or up to 500m/20km via fibre optic modules
Multi/Single Mode. The KVM signals are transmitted either via Cat.6 or via Duplex LC cables. The Extender
uses digital transmission ensuring there is no signal degradation as is typically experienced when using KVM
extenders for analogue VGA signals.
This extender family supports digital DVI-D Single Link signals up to 1920x1200. For reasons of space, the
Extenders 39200 - 39202 use HDMI receptacles, but HDMI features such as audio, HDCP, YUV/YCbCr,
deep colour are NOT supported.
This extender family supports almost all USB 1.1/2.0 devices, but USB flash drives and USB hard drive
enclosures are supported only by extender versions with Mass Storage support - this option can be upgraded
if required via paid unlock code (SN based) - please contact LINDY support. LINDY support also can provide
additional information for various mounting kits.
For the whole extender product family the following additional features can be upgraded via SN-related paid
unlock code (combinations of unlocks are also possible):
Mass Storage option, analogue audio option*, VGA option*, RS232 option*, matrix switching option.
* marked options are only available for models with DVI ports!
The matrix switching option introduced in 2015 requires the connection of all extender boxes via one Gigabit
switch. Each KVM connection requires 1Gbit/s bandwidth! Therefore switches cannot be cascaded, or they
require at least a 10Gbit/s. connection. Therefore as also for security reasons the KVM network must be
always separated.
Options must be purchased exclusively for the receiver and will automatically become available on the
connected transmitter. The VGA option allows the feeding of VGA sources, VGA signals are digitized and
transmitted and output as digital DVI-D signals from the receiver. Back conversion back to VGA requires an
additional external converter. In a Matrix Switching network options must be purchased for all receiver units.
In the versions with fibre optic connection the SFP module can be replaced against a single mode version
for distances up to 20 km.
Packaging Content TX and RX
1x Transmitter (TX)
1x power supply incl. 4 adapters
1x DVI-HDMI respectively DVI-DVI cable, 2m
1x USB cable A/B, 2m
4x housing feet
2x self-adhesive hook and loop pad
Manuals (DE, EN, FR, IT)
Installation, Operation
The KVM extender basically consists of a transmitter (TX) and receiver (RX). The TX (see product label or
imprint local / pc on the front panel) connects the computer or the DVI signal source to the KVM extender by
enclosed monitor and USB cables. The RX provides a bypass port for a local monitor.
The RX (see product label or imprint remote / mon on the front panel) connects to the user console, the
monitor by the enclosed monitor cable. The RX supports direct connection of 4 USB devices and/or USB
hubs as well.
If you want to secure the transmitter and receiver to prevent slipping, attach the self-adhesive hook and loop
pads (enclosed) to the underside of the device. Accessories like mounting brackets, DIN rail, as well as a 19
inch rack mount shelves are available on option – please contact LINDY support.
Dieses Produkt unterliegt kontinuierlicher technologischer Weiterentwicklung.
Das OSD und die Funktionalität kann von der hier beschriebenen leicht abweichen
1x Receiver (RX)
1x power supply incl. 4 adapters
1x DVI-HDMI respectively DVI-DVI cable, 2m
4x housing feet
2x self-adhesive hook and loop pad
Manuals (DE, EN, FR, IT)
2
Advertisement
