Advertisement
Menu item "G" - Extender settings: this menu leads to
another further submenu of other settings:
Sub-menu item "V" - VGA digitization settings. When the
VGA option is enabled a VGA input signal can be digitized
automatically and manually. The M command toggles
between Auto-detect / DVI / VGA. The K command allows
the manual VGA fine tuning using the keys F1 through F8.
During manual adjustment the space bar changes the rate
of change cyclically.
I button restores the default settings.
Sub-menu item "A" - amplification of the audio input on the
remote unit. The default is 5, 0 turns off the input signal, 9 is the
maximum gain.
Sub-menu item "R" - RS232 settings. The D9 interface
assignment is as follows: pin 3 transmit data, 2 receive data, 4 DTR,
8 CTS. The universal rate of 9600 transfers all RS232 transparent
configurations. The following settings are available: baud rate: 4800,
9600, 19200, 38400, 57600, 115200, 230400; Parity: No, odd, even,
mark, space; Stop bits: 1, 2.
Sub-menu item "S" - show last image. When this function is enabled the Extender shows the last
transmitted frame before a connection was aborted instead of a black screen. The screen then is marked
with red flashing frame.
Submenu item "I" - Monitor sync. Synchronizes the image refresh rate of monitor with graphics card, what
can be useful for multimedia content. Because not all monitors support this function the default setting is off.
A flickering monitor is an indication that he does not support this function.
Sub-menu item "L" - lock menu. Here, it can be set whether or not
the access to the OSD 5 minutes after switching on is blocked.
Sub-menu item "P" - Power save menu. Here, the behaviour of
the monitor power save mode is set. If the Extender receives no
video signal it can also turn off its output signal so that the connected
monitor also switches to power save.
Sub-menu item "N" - noise filter. Here, an image enhancement
for content with very high dynamics (video with very rapid image
changes or noise) can be set. If for such signals the frame rate drops
below a critical limit a noise filter can improve the image transfer. It
should only be enabled together with the monitor sync option above and not without real need.
Sub-menu 'Q' - exits the sub-menu.
This product is subject to continuous technological development.
4
The OSD and the functionality may differ slightly from the one described here
Advertisement
