Clincher Backup Jaw Removal/Installation - Farr KT5500 Technical Manual

S & o
ETup pERaTIon
4. CLINCHER® Backup Jaw Removal/Installation
i. Extend CLINCHER® cylinders enough so that the hex flat-head cap screws securing the die retainer tabs are well
exposed. Turn off hydraulic power.
ii. Remove the two hex flat-head cap screws securing the die retainer tab on the top of the CLINCHER® die.
iii. Remove the top die retainer tabs.
iv. Slide the die straight up, and remove.
KT5500 5-
1
/
T M
ECHnICaL anuaL
" T & CLInCHER® B
ong
2
S C
ECTIon onTEnTS
aCKup
2.15