Silvercrest SADP 4 A1 Operating Instructions Manual page 19

Activity tracker
Hide thumbs

Advertisement

Table of Contents
Activity time mode /
In Activity time mode you can see how long you were active during the course of the day.
The time is measured in hours and minutes. At midnight, the active time is set back to zero.
/
Target monitoring mode /
In Target monitoring mode you can see how close you are to your target as a percentage.
The smiley changes the closer you get to your target. If you exceed your goal, this is
shown. The display goes up to a max. of 999%. You can use the SilverCrest Smart-
Active app either to activate both views
/
or just one of the two.
Vibration alarm mode /
By default, the Vibration alarm mode is disabled. You can use the SilverCrest Smart-
Active app to set and name up to 5 alarms. You can also set when the alarm should
repeat. Before it goes off, you can disable a set alarm only via the SilverCrest Smart-
Active app. When a set alarm goes off, the tracker vibrates and the name of the alarm
appears on the display
. Press the menu button
to turn off the alarm. Otherwise the
alarm will turn itself off after a few seconds.
Inactivity reminder mode /
In Inactivity reminder mode you can set an inactivity alarm via the SilverCrest Smart-
Active app. The inactivity duration specifies the maximum period of inactivity after which
the inactivity alarm on your tracker will be triggered. You can set a start and end time
during which the Inactivity reminder mode is active. If the inactivity alarm is triggered,
the tracker vibrates and the display
alternates between / . Press the menu button
to turn off the alarm. Otherwise the alarm will turn itself off after a few seconds.
Sleeping mode /
In Sleeping mode you can record your sleeping quality and time. You can use the
SilverCrest SmartActive app to make individual sleep settings.
The tracker does not automatically recognise that you are sleeping. You will need to
activate Sleeping mode by pressing the menu button
for 3 seconds. In Sleeping
mode,
appears on the tracker's display
next to the time. From now on, your sleep
quality and time is recorded. In Sleeping mode, you cannot switch between modes.
To exit Sleeping mode, press and hold the menu button
for about 3 seconds.
You will switch back to Time mode. You can look at the results of the recording using
the SilverCrest SmartActive app. Alternatively, you can also set your sleeping time in the
SilverCrest SmartActive app. This prompts the tracker to switch to sleeping mode or time
mode, respectively, when the set sleeping time begins or ends.
GB │ IE │ NI
16 
SADP 4 A1

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

  Also See for Silvercrest SADP 4 A1

Table of Contents