FIGURE 1 Dynamic IPv6 routing example in RIPng
Enabling forwarding on R1 and R2
For R1 to pass data between the dp0p1p1 and dp0p1p3 interfaces and R2 to pass data between the dp0p1p1 and dp0p1p2 interfaces, R1
and R2 must be configured to enable forwarding. To enable forwarding on R1, perform the following step in configuration mode.
TABLE 1 Enabling forwarding on R1
Step
Enable forwarding on R1.
Commit the change.
To enable forwarding on R2, perform the following steps in configuration mode.
Step
Enable forwarding on R2.
Commit the change.
Enabling RIPng on an interface
To allow dynamic routing by using RIPng, RIPng must be enabled on the interfaces that are to use it. To enable RIPng on R1, perform the
following steps in configuration mode.
12
Command
vyatta@R1# delete system ipv6 disable-forwarding
vyatta@R1# commit
Command
vyatta@R2# delete system ipv6 disable-forwarding
vyatta@R2# commit
RIPng Configuration
Brocade 5600 vRouterRIPng Configuration Guide, 5.0R1
53-1004512-01