Table of Contents
Advertisement
BTS3900L (Ver.C)
Installation Guide
l
l
Figure 11-13
Figure 11-13 Small Configuration Scenario I
Procedure
Step 1 Measure the distance between the DCDU-11A and the external power supply equipment
according to the actual cable route, and then prepare power cables of a proper length.
Step 2 Add an M6 OT terminal to one end of the power cables. For details, see Assembling the OT
Terminal and the Power Cable.
Step 3 Remove the protective cover from the terminal block of the DCDU-11A.
Step 4 Connect the blue cable to the wiring terminal labeled NEG(-) and black cable to the wiring
terminal labeled RTN(+).
Step 5 Use a screwdriver to tighten the screws on the wiring terminals.
Step 6 Install the protective cover, and then use a screwdriver to tighten the screws.
Figure 11-14
Issue 07 (2013-11-08)
3 large-power modules + 3 small-power modules + 1 or 2 BBUs, and RFUs in upper and
lower shelves.
3 large-power modules + 1 or 2 BBUs, and RFUs in uppoer or lower shelf.
NOTE
Two 80A air switches, one of them for upper or lower DCDU.
shows the small configuration scenarios.
shows the installation process.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Installing the Cables
75
Hide quick links:
Advertisement
Table of Contents
