Unpacking And Assembly; Unpacking The Ct-1000; Assembly Procedure - Cannon CT-1000 Manual

Constant temperature bath

Hide thumbs Also See for CT-1000:

Table of Contents

UNPACKING AND ASSEMBLY

This chapter of the manual provides assistance in unpacking and assem-

bling the CT-1000 Constant Temperature Bath. For additional assistance,

consult the instructional video.

The CANNON

CT-1000 Constant Temperature Bath is shipped in two

boxes:

Box 1 contains the glass jar, front glass panel pieces, jar gasket top,

trimpot adjust screwdriver, Allen wrench, seven hole covers, rubber

thermometer holder and instruction manual.

Box 2 contains the bath housing, including the electronics drawer.

Box 2 also contains a smaller box with the motor and stirrer, including

the impeller and mounting plate.

The bath unit housing is shipped completely assembled. However, the

glass jar, the glass panels, and the motor and stirrer must be installed in it.

To allow this, some disassembly of the bath unit housing is required. The

tools required are a utility knife, phillips screwdriver, and a 1/8" Allen

wrench. The Allen wrench is included with the bath.

1. Unpack the bath unit housing.

Figure 2: Primary bath components after unpacking

CT-1000 Constant Temperature Bath

CANNON

Revision 3.1a—February, 1998; CANNON

P.O . Box 16 • State College, PA • USA

Instrument Company

Table of Contents