Extra Function Buttons - Bernina Bernette Rome 8 Instruction Manual

26 Operating Instructions

Extra Function Buttons

Start/stop button
Press the start /stop button to start the
machine. Press again to stop it.
machine will rotate slowly at start of sewing.
This way you may operate the machine
without foot control.
The button light up depending on how the
sewing machine is being operated.
Green: When the machine is ready to start.
Red: When the machine is sewing or
winding the bobbin.
Needle up/down button
By pressing the needle up/down button the
needle will make half a stitch. Depending on
the actual needle position it will stop in the
opposite position, either at the highest or the
lowest position. At the same time the needle
stop position after sewing is permanently set.
The needle stop position is shown on the LCD.
Press the button so the arrow on the LCD
points upward " " the needle moves to the
highest position and will stop there after
sewing.
Press the button so the arrow on the LCD
points downwards "
the lowest position and will stop there after
sewing.
Please Note
During sewing, press the needle up/down
button, the machine will stop automatically.
Auto-lock button and single pattern
When the patterns 01-05 or 24
the machine will immediately sew 3 locking
stitches when the auto-lock button is
pressed, then automatically stop.
The LCD will display the figure "
machine is stopped.
Except for the pattern 01-05, 10, 24 and 45-
55 , press the auto-lock button, the machine
will sew 3 locking stitches at the end of the
current pattern and automatically stop.
The LCD will display the figure "
the machine is stopped. The function will be
cancelled if you press the button once again
or select another pattern.
The
" the needle moves to
are selected,
" until the
" until