Bernina Bernette Rome 8 Instruction Manual page 26

Operating Instructions 25
Stitch length adjustment buttons
–
To shorten the stitch length, press the " "
button.
To increase the stitch length, press the "+"
button.
The stitch length can be adjusted between
"0.0-4.5 mm". Certain stitches have a limited
length.
When you select a stitch the machine will
automatically set the recommended stitch
length which will be indicated by numbers on
the LCD screen.
Stitch width adjustment and memory
scroll buttons
–
For a narrower stitch, press the " " button.
For a wider stitch, press the "+" button.
The stitch width can be adjusted between
"0.0-7.0 mm". Certain stitches have a limited
stitch width.
When you select a stitch, the machine will
automatically set the recommended stitch
width, which will be indicated by numbers on
the LCD screen.
With pattern 01-03 or 24 selected, the
needle position is shown on the screen. The
position can be adjusted by the stitch width
adjustment buttons .
–
Pressing the " " button, will move the needle
to the left and pressing the "+" button, will
move the needle to the right. There are a
total of 15 needle positions.
(7 left, 7right, and 1 center)
In memory mode the stitch width adjustment
buttons serve two purposes: the stitch width
adjustment as well as to navigate between
the different memory locations.
Speed limiting slider
By adjusting the position of the speed
limiting slider the top speed during sewing
may be limited. The position of the slider
defines the sewing speed at full stroke of the
foot controller.
–
For slower speed: Slide toward ( )
For higher speed: Slide toward (+)
When the machine is run with the start/stop
button the position of the speed limiting
slider defines the actual sewing speed.