Descaling: Group Head & Steam Wand - Sunbeam EM4300 User Manual

Descaling: Group Head & Steam Wand
Step 1. Steam Wand Descaling
- To start the Descaling Program turn the
DIAL to the STEAM position.
The ON/OFF & STEAM LIGHTS will now
start a flashing combination once every few
seconds.
The Pump will start and hot water will run
from the Steam Wand. Over a 2 minute
period the Pump will make different noises.
When the hot water has stopped being
released from the Steam Wand, this step
has finished.
The flashing light combination will change
to the ON/OFF & READY LIGHTS.
- Move to Step 2.
Important: In-between each of the
Descaling Steps there is a maximum of
5 minutes allowed to start the next step
before the Descaling Program will exit.
Step 2. Group Head Descaling
- To continue turn the DIAL directly to the
ONE CUP position (do not stop at the ready
position).
The ON/OFF & READY LIGHTS will continue
a flashing combination once every few
seconds.
The Pump will start and hot water will
run from the Group Head. Over a 2 minute
period the Pump will make different noises.
When the hot water has stopped being
released from the Group Head, this step
has finished.
The flashing light combination will change
to the ON/OFF & STEAM LIGHTS.
- Move to Preparing for Purge section.
Preparing for Purge
The Steam Wand and Group Head now
need to be purged clean with fresh water to
remove descaling solution.
• Rinse Water Reservoir
Remove the Water Reservoir & rinse
thoroughly under running water, ensuring
that all traces of the descaling solution
have been removed.
• Fill Water Reservoir
Fill the Water Reservoir to the 'MAX' line
with clean water and replace.
• Empty Containers
Empty water from the containers and replace.
- Move to Step 3.
Step 3. Steam Wand Purge
- To continue turn the DIAL directly to the
STEAM position (do not stop at the ready
position).
The ON/OFF & STEAM LIGHTS will continue
a flashing combination once every few
seconds.
The Pump will start and hot water will run
from the Steam Wand. Over a 2 minute
period the Pump will make different noises.
When the hot water has stopped being
released from the Steam Wand, this step
has finished.
The flashing light combination will change
to the ON/OFF & READY LIGHTS.
- Move to Step 4.
Step 4. Group Head Purge
- To continue turn the DIAL directly to the
ONE CUP position (do not stop at the ready
position).
The ON/OFF & READY LIGHTS will continue
a flashing combination once every few
seconds.
The Pump will start and hot water will
run from the Group Head. Over a 2 minute
period the Pump will make different noises.
When the hot water has stopped being
released from the Group Head, the
Descaling Program has finished.
Complete
The ON/OFF LIGHT will be fully illuminated
and the READY LIGHT will flash to show the
Descaling Program has finished.
- Return the DIAL to the vertical READY
position.
- Empty water from the containers.
21